Flaming River Keyless Ignition Systems - Manual

1
INSTALLATION INSTRUCTIONS PUSH BUTTON START SYSTEM
SYSTEM OVERVIEW
The PUSH BUTTON START SYSTEM supplements a standard automotive ignition switch with
a radio controlled secure start system. The driver is able to control the ACC, IGN, and STR
functions by use of an illuminated push button.
The system is designed to be wired in parallel to the existing ignition switch.
The switching functions of the ignition switch, which in a standard automotive system are
used to switch battery power to accessory, ignition, and starter circuits, are replaced by
3 relays controlled by the PUSH BUTTON START SYSTEM. The individual relays are used to
provide the system power to the accessory, ignition, and starter circuits.
CONTENTS:
Near Reader Module Push Button Switch
FLAMING RIVER INDUSTRIES, INC 800 POERTNER DRIVE BEREA, OHIO 44017 800.648.8022
©2010 FLAMING RIVER INDUSTRIES, INC. ALL RIGHTS RESERVED.
INSTALLATION - WIRING OVERVIEW
Instruction Sheet
Main Were Harness
Remote Keyless Entry (RKE) System
PART NUMBER FR60003
Before beginning the installation, please review the most recent instructions at:
http://aftermarket.strattec.com. For questions concerning installation or performance,
please call 1-800-648-8022.
Revised 7/28/10
Notes to the Installer:
1. If this is the first time you have installed the FLAMING RIVER PUSH BUTTON START SYSTEM into a vehicle, it is recommended that the complete system should be temporarily
powered up and tested outside of the vehicle prior to final installation and hard wiring into the vehicle. Either a standard 12 volt battery or a 12 VDC power supply is adequate to
power the system. Fuses should be inserted as needed into the supply circuit. This bench-top testing of the system will allow the installer to become familiar with the operation of
the system as well as the wiring, fusing, and load requirements.
2. Follow good automotive wiring practice for installation of the system.
3. All wires on the switch harness, main harness, and relay harness are printed to show the connection to/from information. In addition, a wire chart is included in the instructions to
show the wiring information.
4. The system uses the Deutsch DTM type connectors for connection to the main and antenna harnesses. All connectors are keyed with different unique housing configurations. The
Deutsch connectors may be disconnected and reconnected as needed to route the harness and antenna wires as needed. Do not remove the individual wires from the Deutsch
housing shells unless the wires are damaged and require repair.
Docking Station Relays
Docking Station Face Plate Docking Station Mounting Hardware
Relay Harness
FOB
Push Button Switch Harness
INSTALLATION INSTRUCTIONS PUSH BUTTON START SYSTEM
SYSTEM OVERVIEW
CONTENTS:
INSTALLATION - WIRING OVERVIEW