Flaming River Long-Shaft Mustang Box FR1497 series - Manual

800 Poertner Drive
Berea, OH 44017
1-800-648-8022
Kit Includes:
NEW FR1497-series steering box (Long shaft) for 1964-1/2-66 Mustang, 1960-66 Ford Falcon,
Ranchero, Mercury Comet
Tools Required:
Pitman arm puller, steering wheel puller, 3/8” drive socket set, Open/Closed box wrench set,
torque wrench, red threadlocker, floor jack, 4 jack stands, straight blade screwdriver, Phillips
head screwdriver (Optional: 3/8” drill, grinding wheel or flat file)
TECHNICAL BULLETIN # 1011
WARRANTY: ONE (1) YEAR FROM DATE OF PURCHASE. REPLACEMENT OF PRODUCT DEEMED
DEFECTIVE BY THE FACTORY.
ANY LABOR INCURRED IS SPECIFICALLY EXCLUDED.
STEERING BOX INSTALLATION INSTRUCTIONS – 1964-1/2-1966 Mustang, 1960-66 Ford Falcon & Ranchero
FR1497-series Long Shaft (including special order units)
NEEDED PARTS (not supplied): None
IMPORTANT: Make certain the wheels are straight ahead before beginning and the vehicle is
properly supported on jack stands. With the wheels straight, mark the top center of the steering
wheel with a piece of tape around the grip to assure the wheel is centered.
Removal of Steering Column
NOTE: All boxes are pre-lubricated and pre-adjusted to factory specifications.
DO NOT ADJUST THE STEERING BOX!!!
The first part of replacement of the steering box is the removal of the steering column. To remove
the column, follow these steps.
1) Disconnect the ground (–) terminal from the battery.
2)
Remove horn button by pushing down on horn hub and turning counter clockwise.
3) Remove steering wheel retaining nut and remove steering wheel (A) by using a steering wheel puller.
4) Disconnect the electrical plug towards the base of the column (B).
5) Before removing the column, see PAGE 3. Fill out wiring color verification form before
proceeding.
6) Remove the column support bracket under the dash. There are two nuts one on each side of the
column. (B-1)
7) Remove the upper bushing located at the center of the turn signal switch.