GReddy AIR INTAKE SYSTEMS: Mitsubishi EvoX 2008-12 User Manual
Installation, Parts identification, Tools required
Installation
1
Complete Stock intake. Please disconnect battery
terminals before installation.
2
Disconnect MAF sensor harness. Loosen clamp using
10mm socket or wrench.
3
Lift and remove bottom half of air box out of vehicle.
7
Install filter adaptor to housing and secure using button
head screws provided. Tighten using 4mm allen key.
Attach rubber trim to top of housing.
8
Install housing into vehicle and position.
9
With 10mm socket or wrench loosen the bolt holding
bottom half of air box.
4
Pull back MAF sensor from intake tube.
5
Un-clip upper half of air box and remove.
6
06-80502 Pg1
Parts Identification:
1
Air filter (
™ 61-90133)
1
Intake tube, 05-T4202P1
1
Housing, 05-T4202B2
1
Adaptor, 3-angle
1
Coupling, straight 05-00664
1
Coupling, reducer 05-00735
1
Clamp #072
3
Clamp #048
1
Rubber trim @ 15”L
1
Screw, hex M6
1
Flat washer M6
3
Screw, button head M6
1
Grommet, rubber
Tools Required:
10mm socket or wrench
Ratchet w/ extension
Flat head screw driver
5/16” nut driver
4mm allen key
Note: Read instructions before
installation and have tools ready.
Kit P/N:
12539002 (POLISHED)
Make:
Mitsubishi
Model:
Year:
Engine:
Lancer EVO X ’08-’12 L4-2.0L turbo