Actiontec electronic GT701WRU - Manual (Page 62)

56
Actiontec 54 Mbps Wireless Cable Router User Manual
57
Chapter 4 Using Advanced Setup
Static Routing
Selecting Static Routing in the “Advanced Settings” screen generates the “Static
Routing” screen. Enter the addresses in their respective text boxes, then click Add.
The address will appear in the “Static Routing Table.” To remove an address, high-
light it by clicking on it in the Static Routing Table, then click Remove.
UPnP (Universal Plug and Play)
Selecting UPnP in the “Configuring the Advanced Settings” screen generates the
“UPnP” screen. In this screen, the Universal Plug and Play option is turned on or
off by activating the appropriate circle.
Universal Plug and Play is a zero-configuration networking protocol that allows
hardware and software (such as Netmeeting) to operate more efficiently. If
Netmeeting is not running properly, activate UPnP.
☞
Note: Activating UPnP presents a slight security risk. After
finishing with the hardware or software using UPnP, Actiontec
recommends deactivating UPnP.