Night Owl 16BL-DVR-5GB - Manual (Page 19)

User’s Manual
17
6.2.1.2 Motion
Red = Motion Detection Enabled
Clear = Motion Detection Disabled
NOTE: You can click and drag the mouse cursor when selecting/deselecting the motion area.
6.2.1.3 Alarm
To configure the Motion Detection function of the
DVR, click “MAIN”
 “Recording Functions” 
“Motion” to enter the Motion Detect Setup window.
Channel: Choose the channel you would like to
configure to have specific motion detection function.
Motion Detection: Enable or Disable Motion Detection
of the selected channel.
Sensitivity: Choose the level of sensitivity of motion
detection. 1 is the least sensitive.
Detection Area: Click this button of the corresponding
channel to select the area you want to have motion
detection. The channel is separated into a 15*10 area.
When any movements in the selected area are detected,
recording or alarm will be triggered. The
semi-transparent area means no motion detection will be
performed in those areas.
Copy: Duplicate the setting of the selected channel to
other channels.
To configure the Alarm mode of each channel, click
“Main Menu”
 “Record Settings”  “Alarm” to enter
into “ALARM SETUP” menu.
Channel: Select the channel you would like to configure
Alarm settings
I/O Status: Select between “NO” (Normal Open), “NC”
(Normal Close), and OFF depending on your external
Alarm.
Copy To: Use the function to duplicate the same setting
of one channel to another.