Outback Power Systems VFX Series Programming Manual - Manual (Page 36)

35
NOTE: If you are doing OutBack Stacking, turn on the FW-X240 Auto Transformer breaker now. Otherwise, go
to the next step.
• Verify the AC voltage output through the MATE following path:
PATH
MAIN--------------------- STATUS------------ STATUS/FX/PAGE1------- Float P00 STATUS/FX/METER—P00
12.15:30p choose device: choose category: inv 0.0Kw zer 0.0kw output 117 vac
chg 0.0kw buy 0.0kw voltage
SUM STATUS SETUP ADV FX CC DC MAIN MODES METER BATT PG2 DOWN STATUS PORT DOWN UP TOP PORT
BYPASS OUTPUT INPUT
With the programming
completed, turn the AC output
breakers ON with the AC
BYPASS on the AC breaker panel
switched to NORMAL.