Outback Power Systems VFX Series Programming Manual - Manual (Page 43)

42
PRESS <INC> UNTIL 141,
THEN PRESS ENTER
ADV/PASSWORD---------------
enter the password
132
ENTER INC DEC EXIT
ADV/SETTINGS/WARNING
changes made could adversely
aff ect system performance
MAIN-------------------------
8:25:04A
SUM STATUS SETUP ADV
ADV---------------------------
choose a device:
FX CC DC MATE
ADV/FX/PAGE 1---------------
choose category:
ADV INV CHGR PG2
ADV/FX/PG2-----------------
choose category:
PG1 GRID GEN PG3
ADV/FX/PAGE3---------------
choose category:
PG2 AUX STACK PG4
ADV/FX/STACK-----------P01
stack 1-2ph Master
phase
DOWN INC DEC PORT
ADV/FX/STACK----------P01
stack 1-2ph Master
phase
DOWN INC DEC PORT
Set the stack phase of the Port
01 FX to 1-2 ph Master using the
<INC> or <DEC> soft keys. Press the <PORT> soft key and
verify P02 displays on the screen.
ADV/FX/STACK----------P02
stack 1-2ph Master
phase
DOWN INC DEC PORT
ADV/FX/STACK------------P02
stack OB Slave L1
phase
DOWN INC DEC PORT
ADV/FX/STACK-----------P03
stack 1-2ph master
phase
DOWN INC DEC PORT
Push the <INC> soft key twice to
set the stack phase to OB Slave
L1 If you have a system with only
two FX’s or you wish to put the
FX connected to Port 2 in series
with the Master, push the <INC>
soft key one additional time (three
times total) to set the stack phase
to OB Slave L2. Press the <PORT> soft key until
Port 03 appears on the screen Push the <INC> soft key three
times to set the stack phase
to OB Slave L2 To put the FX
connected to Port 03 in parallel
with the Master, push the
<INC> soft key two times to set
the stack phase to OB Slave L1.