Wixey WR525 Type 2 REMOTE ROUTER READOUT - Manual

1
INSTRUCTIONS
Wixey
TM
REMOTE ROUTER READOUT
MODEL WR525 Type 2
1- Select the best mounting location
The WR525 can be mounted to a variety of machines in a number of different ways. These instructions
demonstrate the WR525 mounted to a router lift that is laying upside down on its top plate.
The “L” bracket and the magnet bracket can be attached the scale and sensor in many different ways
(FIG 1-2). Determine the best way for your particular situation.
Before attaching the scale and sensor to your lift check the travel with the carriage both fully extended and
tight against the top plate (FIG 3-4).
NOTE :
•
Always turn off the power and unplug your
machine before installing the WR525
The “L” bracket attaches to the top of the Scale
as shown:
M4 pan head
screw
Plastic bushing
and washer “L” bracket
M4 Hex Nut
Scale
Alternate bracket position
FIG 1
Select a position to attach the magnet and bend
one of the straight magnet brackets as needed.
There are 8 possible magnet attachment points
Straight magnet bracket
(2 spares are included)
Attach the magnet
using the M3 Hex Nut
There are many possible
ways to bend and attach
the magnet bracket
FIG 2
Sensor
Fully extended carriage position
Carriage
Top plate
The sensor
must stay
on the
scale
FIG 3
Carriage positioned tight against the top plate
Make sure the
sensor does
not bottom out
FIG 4