Wixey WR500 ELECTRONIC DIGITAL READOUT - Manual

1
Wixey
E L E C T R O N I C
D I G I T A L R E A D O U T
M o d e l W R 5 0 0
INSTRUCTIONS
Step 1- Mounting the readout assembly to your planer
Tighten any of the side cover mounting
screws (1) and if necessary use a small
amount of epoxy adhesive between the
side cover and the base casting to
prevent movement (2). Remove the
scale pointer and keep any screws or
washers (3). Use any standard
household cleaner or degreaser to clean
the front surface of the side cover (4). If
the planer has a scale permanently
attached to the side cover it may be left
in place.
Dewalt DW735 -the readout kit will be
attached directly to the metal scale.
Delta 22-580 13” – See special
instructions on page 10.
Hold the device in place against the right
side cover letting the leveling screw rest
on the foot of the base casting (5). Using
a straight edge adjust the leveling screw
so the flat contact surface of the metal
frame will be level with the table or
slightly above (6). Use the jam nut to
lock the leveling screw in position.
Note: Several different length leveling
screws are provided, select the one that
works best with your planer. If there is
no foot on the base casting to rest the
leveling screw on, you will have to mark
the appropriate location for the frame to
mount to the side cover so that the flat
contact surface of the frame is level or
slightly above the planers table surface.