Wixey WR500 ELECTRONIC DIGITAL READOUT - Manual (Page 2)

2
Peel the paper backing off the 2 foam
tape adhesive strips that are attached to
the back of the frame of your digital
readout (7). Hold the frame a slight
distance from the side cover so that the
adhesive foam does not contact the
cover until the frame is in the correct
position. Carefully align the left edge of
the frame with the edge of the planer
side cover keeping the leveling screw in
contact with the foot of the base casting
(8).
Note for Delta 22-580 13”: the left side
of the frame will be aligned with the
scribed line explained on page 10
Push the frame firmly against the front
of the side cover. If the leveling screw is
resting firmly on the foot of the base
casting, the foam tape will permanently
hold the device to the planer.
If the leveling screw does not firmly
support the frame then screws (not
provided) may be used to attach the
frame to the side cover using the holes
provided (9). Carefully slide the scale
up and out of the bottom portion of the
frame to expose the pre-drilled holes in
the frame. Make sure that the end of the
screws protruding through the side cover
do not interfere with the up and down
movement of the planers cutter head.
Note: for Dewalt model DW735: There
is no side cover on this model. The
frame can be attached directly to the
steel scale. Since there is no base
casting foot, screws will need to be used
to attach the frame to the planers steel
scale.