Vaisala HMT120 - Manual (Page 71)

Chapter 6 ____________________________________________________________ Troubleshooting
VAISALA ________________________________________________________________________ 69
Analog Output Error Notification
If the transmitter is unable to operate due to an error, the analog outputs
will be set to an error level.
Default output current in error state is 3.6mA. Error current value can be
changed via the serial interface by using the AERR command; see
section Set/show Analog Output Error Levels on page 38.
Technical Support
For technical questions, contact the Vaisala technical support via e-mail
at [email protected] .
For contact information of Vaisala Service Centers, see
www.vaisala.com/servicecenters .