Vaisala MM70 - Manual (Page 18)

USER'S GUIDE____________________________________________________________________
0605-080
Figure 5 Tightening Clasp Nut
The following numbers refer to Figure 5 on page 16 above
1 = Probe
2 = Clasp
nut
3 = Fitting screw
4 = Pen
NOTE Take care not to over tighten the clasp nut to avoid difficulties when
opening it.
When the probe is used in a pressurized processes the sensor head
should preferebly be installed through a ball valve assembly.
16 __________________________________________________________________ M210498EN-C