Vaisala TCI101 NiteStar - Manual (Page 22)

HYPERTERMINAL SET-UP FOR NS-60
Hyperterminal is a terminal emulation program that comes built
into Windows. You can use it to control your NS-60 via a serial
link. The controls for the NS-60 are the keys.
KEYBOARD Serial Commands (Simple Command Set)
Serial Command - NITESTAR Key
__________________________
S RUN/HOLD key
H DISP/HOLD Key
C CLEAR/RESET Key
CR MARK/ENTER key
1 CAL key
2 UNIT key
3 PREDIST key
4 UP/DOWN key
5 Display Brightness key
6 PRINT key
7 SPEED key
8 PDI key
9 PRM key
0 VIEW key
Before using Hyperterminal with your NS-60 you must define a
connection and then you will only have to click the connection
Icon to use it again.
SETTING UP HYPERTERMINAL
From the START menu:
40
Double click on HYPERTERMINAL you will get:
The program will start and you will get a dialog asking you to cre-
ate a connection description. What follows is the setup you have
to do ONCE so Hyperterminal will work with your NS-60. Name
the description "Nitestar" and give it an ATOMIC icon.
Click OK to move to the next step.
It will then bring up a dialog asking you about the phone number,
in the Connect Using field we pick Direct to Com1. Here you
would pick COM1 or COM2 depending on which port you will be
using. Consult your computer manual to determine which you will
be using.
Next you will be asked to set the serial I/O parameters.
41