Vaisala WAT12 - Manual (Page 19)

Chapter 3 __________________________________________________ Installation
VAISALA__________________________________________________________17
0206-046
Figure 8 Cable Shield Bent over the Plastic Sleeve
and O-ring
The WAT12 transmitter has three I/O connectors as listed in
Table 4 on page 18. For the location of the connectors, refer
to Figure 9 below.
0206-047
Figure 9 I/O Connectors
The following numbers refer to Figure 9 above.
1 = X1: For the anemometer cable
2 = X2: For the power and signal cable
3 = X3: For the wind vane cable