HighPoint RocketRAID 2314 - Manual (Page 66)

4 - Updating the Driver
To update the driver, simply reinstall the driver following the steps in previous
section, “ Install RocketRAID driver on an Existing System “.
Note: If the driver is loaded in initrd (when system is installed onto a disk or array
attached to the RocketRAID host adapter), you need to run the mkinitrd command to
update the initrd file. If you are using the lilo boot loader, run lilo again (# lilo).
5 - Uninstalling the Driver
To uninstall the RocketRAID 231x driver
Note: The driver cannot be uninstalled while the system is booted from a disk or array
attached to the RocketRAID host adapter.
To uninstall the driver, remove the lines added to /etc/modules.conf and /etc/fstab.
Linux Driver Support
5-14