Red Lion PAXCK - Manual (Page 27)

27
7-SrL Serial Communication Parameters
DISPLAY PARAMETER
FACTORY
SETTING
USER SETTING
bAUd BAUD RATE 9600
dAtA DATA BITS 7
PAr PARITY BIT Odd
Addr METER UNIT ADDRESS 00
Abbr ABBREVIATED PRINTING NO
REAL-TIME CLOCK PRINT FORMAT YES
OPt PRINT OPTIONS
t-dSP TIMER DISPLAY YES
C-dSP CYCLE COUNTER DISPLAY NO
rtC-d RTC DATE DISPLAY NO
rtC-t RTC TIME DISPLAY NO
spNt SETPOINT VALUES NO
SPNtOF SETPOINT OFF/ TIME-OUT VALUES NO
PARAMETER USER SETTING
FACTORY
SETTING
dSP-t 12-59p
dSP-d DATE DISPLAY FORMAT 12-31
SyNC
Ch-dSt
sLAVE
N0
OFFSEt
CAL
00
TIME DISPLAY FORMAT
DISPLAY
AUTO TIME CHANGE FOR D.S.T.
SYNCHRONIZATION UNIT TYPE
CALIBRATE REAL-TIME CLOCK
RTC CALIBRATION OFFSET VALUE
9-fCS Factory Service Parameters
DISPLAY
DISPLAY INTENSITY LEVEL 3 d-LEV
FACTORY
SETTING
USER SETTING PARAMETER
Shaded areas are model dependent. Shaded areas are model dependent.
8-rtC Real-Time Clock Parameters
OUt-n
tOUt-n
SPOF-n
OFF-n
SP-n
ON-n
ASM-n
ACt-n
DISPLAY
NOr NOr NOr NOr SETPOINT ANNUNCIATOR
POWER-UP STATE
NO NO NO NO OUTPUT RESET W/DISPLAY RESET
NO NO NO NO TIMER/COUNTER AUTO RESET
NOr NOr NOr NOr OUTPUT LOGIC
VALUE VALUE VALUE
000100
000100
000100
VALUE
000100
VALUE
VALUE
000100
000100
000100 SETPOINT OFF VALUE (B)*
VALUE
SETPOINT OFF (B)*
TIME-OUT VALUE (B)*
TIME-OUT VALUE (A)
000100 SETPOINT OFF VALUE (A)
VALUE SETPOINT OFF (A)
LAtCH LAtCH LAtCH
VALUE
NO
Mon-Fri
Mon-Fri
Mon-Fri
Mon-Fri
000000
000000
VALUE
VALUE
NONE
SP-4
USER SETTING
NO
Mon-Fri
Mon-Fri
Mon-Fri
Mon-Fri
000000
000000
VALUE
NONE
SP-3
LAtCH
FACTORY
SETTING
USER SETTING
FACTORY
SETTING
VALUE
NO
Mon-Fri
Mon-Fri
Mon-Fri
Mon-Fri
000000
000000
VALUE
VALUE SETPOINT ON (B)*
NONE
SP-2
SETPOINT ACTION
USER SETTING
NO TIMER STOP
Mon-Fri DAILY OFF OCCURRENCE (B)*
Mon-Fri DAILY OFF OCCURRENCE (A)
Mon-Fri DAILY ON OCCURRENCE (B)*
Mon-Fri DAILY ON OCCURRENCE (A)
000000 SETPOINT ON VALUE (B)*
000000 SETPOINT ON VALUE (A)
VALUE SETPOINT ON (A)
NONE SETPOINT ASSIGNMENT
SP-1 6-SPt Setpoint (Alarm) Parameters
FACTORY
SETTING
USER SETTING
FACTORY
SETTING
PARAMETER
PAXCK Application
A big application request has always been for
Real-Time Clocks to display time throughout the
plant. The challenge has been to keep all the
various clock locations synchronized with the
right time. With the new PAXCK Timer/Real-
Time Clock this problem is history. The clocks can
be provided in three different sizes, the PAXCK
(0.56 inch LEDs), the LPAXCK (1.5 inch LEDs),
or the EPAX (4 inch LEDs). You can mix and
match any number of the two versions, up to a
maximum of 32 units. Simply select one of the
units in the system as the host and the balance are
programmed as slaves. The host will send out a
synchronization pulse every hour to correct the
time on any clock unit wired in the system.
Real-Time Clock Synchronization Network
* See Module 2, Exchanging Parameter Lists, for details on programming this value.