Alto-Shaam 1767-SK/III - Manual (Page 16)

767-SK/III, 1767-SK/III, 2800-SK/III INSTALLATION / OPERATION / SERVICE MANUAL PG . 15
O P E R A T I N G I N S T R U C T I O N S
Preset Menu Keys:
This Alto-Shaam oven allows the operator to set up to eight cook/smoke programs. Each program can be
preset in any program mode to cook/smoke by time or internal product temperature. Programs are recalled
and stored using the P
RESET
Keys labeled "A through H." These keys, along with the key labeled "I", share
additional functions described in the "User Options" section of this manual.
Programming a Cook/Smoke Program
Select the product to be programmed and begin programming with the oven control power
O
FF
. Press and release control O
N
/O
FF
key. The oven will beep for one second and power
to the unit will be indicated by an illuminated green indicator light located in the upper left
corner of the O
N
/O
FF
key. The oven will begin operating in the hold mode. The amber
H
OLD
indicator will be illuminated and the last set hold temperature will be displayed.
Press H
OLD
Key. To change the hold temperature, press the U
P
or D
OWN
A
RROW
Key.
Press C
OOK
Key. Oven preheat indicator will illuminate and the last set cooking temperature
is displayed. To change the cook temperature, press the U
P
or D
OWN
A
RROW
Keys.
To cook by time — press the T
IME
Key. Last set cooking time is displayed.
To change the set time, press the U
P
or D
OWN
A
RROW
Key. The green T
IME
indicator will illuminate.
To cook by probe — press the P
ROBE
Key. Last set internal product temperature is displayed.
To change the set temperature, press the U
P
or D
OWN
A
RROW
Key. The green P
ROBE
indicator will illuminate.
Press S
MOKER
Key. To set the smoke time desired, use U
P
or D
OWN
A
RROW
key. The last set
time will be displayed.
The oven preheat indicator will illuminate. Oven is now in the preheat mode and is
automatically programmed to preheat to the cook temperature.
Select a letter code for the product programmed by the previous steps. Press and hold the selected
P
RESET
key until you hear a brief, four second beep. The letter key program indicator light will
illuminate and the product programmed is now stored in memory for the specific letter key pressed.
Additional programs can be stored in the remaining P
RESET
Keys if not previously programmed.
Note: The last P
RESET
Key used will be the oven cooking run sequence for the next product
to be programmed. Settings can be manually changed for the next product and an alternate
pre-programmed letter key selected.
Erasing a Cook/Smoke Program
To erase a program, the oven must be in either the power-up hold mode or in the preheat mode. The oven
cannot be running a P
RESET
Menu program.
When the oven is in the power-up hold mode or in the preheat mode, press and hold both the C
ANCEL
Key and
the appropriate letter P
RESET
Key to be erased. The oven will beep in approximately four seconds and the
program's indicator light will go out to indicate the program has been erased.
IMPORTANT - After programming a specific product into memory in a programmable
preset key, it is very important to make a written permanent record of the product and
the program letter assigned. Menu card (PE-23384) is provided for this purpose.
— or —
PRESETS A