AT&T CL81100 - Manual (Page 22)

Troubleshooting
Appendix
The charge light is off or blinking.
Make sure you plug the power and line cords in correctly
and securely.
Unplug the electrical power. Wait for 15 seconds, then plug it
back in. Allow up to one minute for the cordless handset and
telephone base to reset.
Clean the cordless handset and telephone base charging
contacts each month with a pencil eraser or cloth.
A blinking
CHARGE light is an indication that the battery is not
connected to the handset or missing completely. Ensure that the
battery is installed properly.
Common cure for electronic equipment.
If the telephone does not seem to be responding normally, try
putting the cordless handset in the charger. If it does not seem to
respond, do the following (in the order listed):
Disconnect the power to the telephone base.
Disconnect the cordless handset battery, and spare battery,
if applicable.
Wait a few minutes.
Connect power to the telephone base.
Re-install the battery, and place the cordless handset into
the charger.
Wait for the cordless handset to re-establish its connection
with the telephone base. Allow up to one minute for this to
take place.
•
•
•
•
•
•
•
•
•
•
18