Setup options – Videoswitch VS-28 User Manual
Page 11
VS Series 2
User Manual
Page 9
Video Switch
VST605C.DOC
7. Setup
Options
The switcher is provided with an 8-way DIL switch (referenced as S21) for setting
various user options. It is accessible via a cut-out in the base of the unit near the
front.
7.1 Number of Cameras
Use these three switches to specify the number of cameras in the system. If there
are less than eight cameras, connect them to consecutive camera inputs, starting
with input 1.
Number of Cameras S21-1
S21-2
S21-3
*Programmable OFF
OFF
OFF
2 ON
OFF
OFF
3 OFF
ON
OFF
4 ON
ON
OFF
5 OFF
OFF
ON
6 ON
OFF
ON
7 OFF
ON
ON
8 ON
ON
ON
*The Programmable option allow the operator to individually specify which cameras
are to be sequenced on the Monitor A output and which cameras are to be
sequenced on the Monitor B output:
Specify Monitor A cameras to be sequenced:
(a)
Press and hold the AUTO A key.
(b)
Press and hold the SET key
(c)
Press the Monitor A cameras keys (1-8) as required to turn on and off the
cameras LEDS. Turn on all the LEDs corresponding to cameras that you wish
to be sequenced.
(d)
Release all keys. Two audible bleeps indicate that the setting has been stored
(4 bleeps indicate an error. If this happens, perform all settings again).
(e)
Set the dwell time to the required period using the SET and AUTO A keys
only.
Specify Monitor B cameras to be sequenced (VS-28 and VS-28A only):
(a)
Press and hold the AUTO B key.
(b)
Press and hold the SET key