Videoswitch VS-28 - Manual (Page 5)

VS Series 2 User Manual Page 3
Video Switch VST605C.DOC
2. Getting Started
1/ Connect the switcher up as shown:
This diagram show the VS-28A. For other switchers, fewer camera inputs and
monitor outputs are available.
2/ Identify the 8 switches on the switcher which are visible through the cut-out in
the base of the unit near the front edge. Set all switches OFF except for
sections 1,2 and 3 which should ON (assuming 8 cameras).
3/ Switch ON the mains power. The switcher powers up in AUTO mode. Press a
camera select key to cancel the auto mode and view a particular camera.