Videoswitch VS-28 - Manual (Page 7)

VS Series 2 User Manual Page 5
Video Switch VST605C.DOC
4. Auto Switching
4.1 Auto Sequencing (Monitor A)
To auto sequence press the “AUTO A” key. The unit will step from one camera to the
next with the previously programmed dwell time.
Only the number of cameras that have been enabled (see section 7.1) will be
selected in the sequence.
4.2 Set Dwell Time (Monitor A)
To set the auto sequence dwell time for monitor A, press and hold the “SET” key on,
then press and hold the “AUTO A” key on for the required dwell duration. The unit
will beep every second. When the required number of seconds has elapsed, release
both keys. When the keys are released, a double bleep confirms that the time period
has been permanently stored.
Note that the Auto Dwell time can not be set if the SET key is locked out (see section
7.3). The dwell time is remembered when the unit is turned off.
4.3 Auto Sequencing (Monitor B)
To auto sequence press the “AUTO B” key. The unit will step from one camera to the
next with the previously programmed dwell time.
Only the number of cameras that have been enabled (see section 7.1) will be
selected in the sequence.
4.4 Set Dwell Time (Monitor B)
To set the auto sequence dwell time for monitor A, press and hold the “SET” key on,
then press and hold the “AUTO B” key on for the required dwell duration. The unit
will beep every second. When the required number of seconds has elapsed, release
both keys. When the keys are released, a double bleep confirms that the time period
has been permanently stored.
Note that the Auto Dwell time cannot be set if the SET key is locked out (see section
7.3). The dwell time is remembered when the unit is turned off.