Dake Model E-V Series - Manual (Page 25)

7/21/08
Manual V-16, V-24, VH-24, V-40 & VH-40
25 – Section I
USE OF STANDARD AND OPTIONAL
ACCESSORIES
CIRCLE CUTTING (OPTIONAL) (figure 1)
(Assembly part number 714801)
The device is used for cutting out perfectly round
objects. Insert the round bar into the corresponding
hole in the guide post, secure with set screw.
Gross radius changes are made moving the cast
assemblies on the round bar, fine adjustments are
done with the thumb wheel.
RIP FENCE Standard all models (figure 2)
(Part number 714805 – Model 24/40/F-16)
(Part number 714869 – Model E-16 only)
Used for cutting material in accurate straight lines. To
attach, insert T-bolt provided in the T-slot in the front of
the table. Slide into the desired position and tighten
handle.
PROFILE CUTTING ATTACHMENT Standard on VH-24 / VH-40 models (figure 3)
(Part number 714821)
This device is used for cutting irregular shapes with
the hydraulic table. Set the chain up as shown in
figure 3. Set the material in the holder and guide with
the hand wheel on the right side of the table. The
excess chain should be coiled out of the way, while
operating the machine.
Note: When chain is not engaged in the rear
sprocket the angle of cut is controlled by guiding
the handles on the holder.
PROTRACTOR HEAD
Standard on 24/40 models. Optional for 16 models
(figure 4)
(Assembly Part number 714800 24/40/F-16 Models)
(Assembly Part number 75561 E-16 Model)
Used for cutting angles 90 degrees to 45
degrees in relation to the blade. It is fastened to
the table by means of T-bolts. The L-shaped bar
is used for additional support of the work. This is
not factory bent.