Kenwood KDC-U7056BT - Manual (Page 16)

16 | Quick Start Guide
Installing/Removing the unit
Non-Japanese cars
Bend the tabs of the mounting sleeve
with a screwdriver or the like and
attach it in place.
<
• Make sure that the unit is installed
securely in place. If the unit is unstable, it
may malfunction (for example, the sound
may skip).
Japanese cars
1
Remove the trim plate with reference to
<Removing the trim plate>.
2
Align the holes in the unit (two locations
on each side) with the vehicle mounting
bracket and secure the unit with the
accessory screws.
8 mm
MAX.
ø5mm ø5mm
8mm
MAX.
3 4
Removing the trim plate
1
Engage the catch pins on the extraction
key (Accessory2) and release the two
locks on the upper part of frame.
Lift up and pull the frame forward as
shown in the figure.
Catch Lock
Accessory 2
2
When the upper part of frame is
removed, remove the lower part of frame.
<
• The frame can be removed from the
bottom side in the same manner.
Removing the unit
1
Remove the trim plate with reference to
<Removing the trim plate>.
2
Remove the faceplate.
3
Insert the two extraction keys
(Accessory2) deeply into the slots on
both sides as shown.
4
Lower the extraction key toward the
bottom, and then pull out the unit
halfway while pressing the extraction key
towards the inside.
Accessory 2
!
• Be careful to avoid injury from the catch
pins on the extraction key.
5
Pull the unit all the way out with your
hands, being careful not to drop it.
B59-2188-10_01_13Stepup_QSG_M_En.indd 16 13/06/04 13:37