Kenwood DNN991HD - Manual (Page 9)

English ñ 9
OEM SETUP (North America Sales area only)
This function requires a commercial adaptor.
Consult your Kenwood dealer for details.
DEMO
Set the demonstration mode. Default is “ON”.
5
Touch [Finish].
✎ NOTE
• For details on operations of each setting, refer to the
Instruction Manual.
6
Touch [Administrator] or [Owner].
Ñ How to prepare the remote control
Insert two “AAA”/“R03”-size batteries with the and
poles aligned properly, following the illustration
inside the case.
!
CAUTION
• Put the remote controller in a place where it will
not move during braking or other operations. A
dangerous situation could result, if the remote
controller falls down and gets wedged under the
pedals while driving.
• Do not leave the battery near fire or under direct
sunlight. A fire, explosion or excessive heat
generation may result.
• Do not recharge, short, break up or heat the
battery or place it in an open fire. Such actions
may cause the battery to leak fluid. If spilled fluid
comes in contact with your eyes or on clothing,
immediately rinse with water and consult a
physician.
• Place the battery out of reach of children. In the
unlikely event that a child swallows the battery,
immediately consult a physician.