Kenwood TS-590S - Manual (Page 78)

70
13 CONNECTING PERIPHERAL EQUIPMENT
DX PACKETCLUSTER TUNE
If you have a TH-D72A/E/ TM-D710A/E/ RC-D710/ TM-D700A/E, you can connect the TH-D72A/E/ TM-D710A/E/
RC-D710/ TM-D700A/E to the TS-590S transceiver to use the DX PacketCluster Tune function. Connect the 2
transceivers with a cross-wired RS-232C cable as shown below. (For connecting to the TH-D72A/E, refer to the
TH-D72A/E instruction manual.)
RC-D710 + PG-5J
TM-D700A/E
TS-590S
TM-D710A/E/
RC-D710 + TM-V71A/E
(m)
(f)
(f)
(f)
PG-5G
RS-232C cross cable
CROSSBAND REPEATER
If you have a Kenwood FM transceiver (K type) with a 6 pin mini DIN connector, you can connect the FM
transceiver to the TS-590S transceiver to use the Crossband repeater function. Connect the 2 transceivers with a
DIN (13-pin)/ mini DIN cable (6-pin) as shown below.
TM-D700A
TS-590S
TM-D710A/ TM-V71A
PR1
SQC
PKS PSQ
PKD
PKS
ANI
ANO
DIN (13-pin)/ Mini DIN (6-pin)
DIN (13-pin) pulg Mini DIN (6-pin) pulg
After connecting the 2 transceivers with the cable, access Menu Nos. 73 (PKS polarity) and 74 (Busy lockout) on
the TS-590S transceiver and select “on”. You will further need to adjust the audio input/ output level of the TS-
590S transceiver using Menu Nos. 66 and 67.