AT&T TL760 - Manual (Page 2)


Getting started
Battery installation
Install the battery as shown below. After installing the battery,
you may be able to make and receive short calls. For optimal
performance, charge the headset battery for at least six hours
before use. When not in use, recharge the headset by returning it
to the headset base.
. Press on both sides of the battery
compartment cover and lift the
cover up and off.
2. Insert the battery into the battery
compartment.
3. Push the battery plug into the
connector inside the compartment
and place the wires neatly inside
place the wires neatly inside
the compartment.
4. Insert the tab on the bottom of
the battery cover into the battery
compartment. Press down gently
on the battery cover until it snaps
into place.
NOTE: Remove the ear hook from the headset before battery replacement.