Alpine IVA-D100 - Manual (Page 29)

25
-EN
01GB05IVA100.fm
ALPINE IVA-D100 68-05946Z49-A (EN)
Adjusting the Audio
1
Press SETUP.
The SETUP selection screen is displayed.
2
Touch [ ] of AUDIO MODE or press and hold the
Rotary encoder for at least 2 seconds on the unit.
The display changes to the AUDIO Adjustment screen.
Display Example for Audio Adjustment Screen
Scrolls the page list up or down.
Scrolls the list item by item.
Touching and holding will scroll continuously.
GlideTouch bar display
For operation, refer to “About the GlideTouch bar”
(page 12).
• Touching [RTN] will return to the previous display.
• When an external audio processor is connected, BASS, TREBLE or
LOUDNESS is not displayed.
Adjusting Bass/Treble
You can change the bass or treble frequency emphasis
to create your own tonal preference.
Touch [ ] to display the Bass or Treble adjusting screen.
Setting the Bass level:
You can emphasize or weaken the bass frequency.
Touch [ ] or [ ] of LEVEL to select the desired bass level.
Setting range:-7 to +10
Setting the Bass Center Frequency:
The displayed bass frequency is emphasized
Touch [ ] or [ ] of FREQ. to select the desired bass center
frequency.
Setting range: 60Hz, 80Hz, 100Hz, 120Hz
Setting the Bass Bandwidth (Q-Factor):
Changes the boosted bass bandwidth to wide or narrow.
A wide setting will boost a wide range of frequencies
above and below the center frequency. A narrower
setting will boost only frequencies near the center
frequency.
Touch [ ] or [ ] of Q (BASS BANDWIDTH) to select the desired
bass bandwidth.
Setting range: 1.25, 1.00, 0.75, 0.5
• The bass level settings will be individually memorized for each
source (FM, AM, CD, etc.) until the setting is changed. The bass
frequency and bass band width settings adjusted for one source are
effective for all other sources (FM, AM, CD, etc.).
Setting the treble level:
You can emphasize the treble frequency.
Touch [ ] or [ ] of LEVEL to select the desired treble level.
Setting range: -7 to +7
Setting the Treble Center Frequency:
The displayed Treble frequency is emphasized.
Touch [ ] or [ ] of FREQ. to select the desired bass center
frequency.
Setting range:7.5kHz, 10kHz, 12.5kHz, 15kHz
• The treble level settings will be individually memorized for each
source (FM, AM, CD, etc.) until the setting is changed. The Treble
frequency settings adjusted for one source are effective for all other
sources (FM, AM, CD, etc.).
Adjusting the Balance
Touch [ ] or [ ] of BALANCE to adjust the sound
volume of the left and right speakers.
Setting range: L15 to R15
Adjusting the Fader
Touch [ ] or [ ] of FADER to adjust the volume of the
front and rear speakers.
Setting range: F15 to R15
Setting the Loudness:
Loudness introduces a special low- and high-frequency
emphasis at low listening levels. This compensates for
the ear’s decreased sensitivity to bass and treble sound.
Touch [ ] or [ ] of LOUDNESS to set to ON or OFF.
Adjusting the Subwoofer Level
Touch [ ] or [ ] of SUBW. LV to adjust the subwoofer
output.
Setting range: 0 to 15
• The level adjustment becomes available when ON is set in
“Subwoofer On and Off” (page 36).
Adjusting NAV. LEVEL
Touch [ ] or [ ] of NAV. MIX LV to adjust the volume of
navigation interruption.
Setting range: 0 to 15
• This adjustment becomes available when NAV.MIX is turned on in
“Setting the Navigation Interruption” (page 35).
• The setting navigation interruption is not displayed if an external
audio processor not compatible with NAV.MIX is connected.
Turning defeat ON or OFF
Touch [ ] or [ ] of DEFEAT to set to ON or OFF.
If you set defeat to ON, adjusted bass/treble values return to
their initial settings.
Other Useful
Features
01GB00IVAD100.book Page 25 Tuesday, February 14, 2006 4:10 PM