Kenwood K-531-SB - Manual (Page 22)

22 K-531
There is no sound while tuning (automatic/manual) is in progress. z
Automatic tuning provides stereo reception while manual tuning provides monaural reception. z
Radio
Preparation:
Connect the antenna cords. (P.8)
Listening to FM/AM radio
1
Press [TUNER/BAND] to select “FM” or “AM”.
You can also select “FM” or “AM” on the main unit by pressing z [INPUT]
to change the input source to “TUNER”, and then pressing [BAND] to
select “FM” or “AM”.
2
Press [AUTO/MONO] to select the tuning mode (automatic
search or manual search).
You can also select the tuning mode on the main unit by pressing z
[TUNING MODE].
If the reception is good, select automatic search. (”AUTO” indicator
z
lights up.)
If the reception is poor, select manual search.
z
3
Press [TUNING
1] / [TUNING ¡] to tune into a station.
You can also tune into a station on the main unit by pressing z [
4]
or [
¢].
If automatic search is selected in step z 2, the System automatically
tunes in to the next station. Repeat this procedure until you are
tuned in to your preferred station.
If manual search is selected in step
z 2, press and hold the button until
you reach your desired frequency.
When a station is tuned in, “TUNED” indicator lights up. “ST.” indicator
also lights up when receiving a stereo signal (only for FM stations).
To select a preset station
Store preset stations beforehand (P.23).
Press z [P.CALL
4] or [P.CALL ¢] to select the previous/next stored
station. To browse through the stored stations, press and hold the button.
Press the number buttons
z to select the desired preset station. (P.13)
To change the display information
Press [ DISPLAY ] repeatedly.
Each time you press the button, the display changes as....
FM: z
Program service name*
= Frequency = Day/Clock = (back to the
beginning)
AM:
z
Frequency
= Day/Clock = (back to the beginning)
* “NO PS” appears if the program service name is not received.
K-531[E_X].indb 22 K-531[E_X].indb 22 12.8.1 11:40:08 AM 12.8.1 11:40:08 AM