Kenwood K-531-SB - Manual (Page 32)

32 K-531
Refer also to the instruction manual that comes with the external component. z
This System can play PCM (32 kHz, 44.1 kHz, 48 kHz, 88.2 kHz, 96 kHz) digital signals. z
External components
Preparation:
Connect an external component to the AUX PLAY IN or DIGITAL IN terminals
on the rear panel. Refer to “Other connections (commercially available
accessories)” for connection (P.9).
Starts playback
1
For playing a component connected to the AUX PLAY IN terminals:
Press [AUX].
You can also start playback on the main unit by pressing z [INPUT] to
change the input source to “AUX”.
For playing a component connected to the DIGITAL IN terminal:
Press [D-IN].
You can also start playback on the main unit by pressing z [INPUT] to
change the input source to “D-IN”.
When
z [D-IN] is selected, the input signal sampling frequency is
displayed.
2
Operate the connected external component to start
playback.
Adjusting the input level for AUX source
Use this adjustment when the volume from an external component is z
noticeably higher or lower than other input sources at the same volume
setting.
1
Press [AUX].
You can also start playback on the main unit by pressing z [INPUT] to
change the input source to “AUX”.
2
Operate the component connected to AUX PLAY IN
terminals to start playback.
3
Press [MODE].
4
Press [
2] or [ 3] to select “INPUT LEVEL”, then press [ENTER].
5
Press [
5] or [∞] to adjust the input level (–3 to +5), then
press [ENTER].
To change the display information
Press [ DISPLAY ] repeatedly.
Each time you press the button, the display changes as....
“AUX” or “D-IN”
= Day/Clock = (back to the beginning)
K-531[E_X].indb 32 K-531[E_X].indb 32 12.8.1 11:40:12 AM 12.8.1 11:40:12 AM