Kenwood K-531-SB - Manual (Page 36)

36 K-531
Adjusting super-bass tones (D-BASS)
The System has a digital signal processor (DSP), which allows you to adjust the
impact of super-bass tones.
1
Press [D-BASS].
2
Press [
5] or [∞] to adjust the level (0 to 10), then press
[ENTER].
Higher numbers give more pronounced super-bass tones. z
“D-BASS” indicator lights up (except if the level is set at 0). z
Adjusting the range levels (TONE)
With the built-in digital signal processor (DSP), you can adjust also the levels of
low-, mid-, and high-range tones.
1
Press [TONE] to select the range tones.
Each time you press the button, the range tone changes as....
BASS (low-range tones)
= MID (mid-range tones) = TREBLE (high-
range tones) = Canceled = (back to the beginning)
2
Press [
2] or [3] to select the frequency.
BASS z 100 Hz, 150 Hz, 200 Hz
MID z 1 kHz, 2 kHz, 3 kHz
TREBLE z 5 kHz, 7 kHz, 10 kHz
You can adjust 1 frequency for each range tone.
3
Press [
5] or [∞] to adjust the level (–8 to +8).
4
Repeat steps 1 to 3 to adjust the other range tones (if
acquired).
5
Press [ENTER] to confirm.
“TONE” indicator lights up (except if the level is set to 0). z
To cancel super-bass tones or range levels
Press [FLAT] .
All level values are set to “0”.
Audio settings
LEVEL (dB)
Variability
Adjusted level Variable frequencies
Frequency Frequency
Frequency
Variability Frequency
Variability Frequency
Variability
LEVEL (dB)
Audio setting adjustments do not affect the sound from components connected to the DIGITAL
OUT terminal or AUX REC OUT terminals, or the sound during recording.
K-531[E_X].indb 36 K-531[E_X].indb 36 12.8.1 11:40:13 AM 12.8.1 11:40:13 AM