Kenwood DDX5025BT - Manual (Page 63)

ENGLISH 63
Error message list
If an error occurs while using the unit, a message
appears. Take appropriate action according to the
following message/remedy/cause list.
“No Signal”/“No Video Signal”:
• Start playback on the external component
connected to the AV-IN1 or iPod/AV-IN2 input
terminal.
• Start playback on the smartphone connected to
HDMI/MHL input terminal.
• Check the cords and connections.
• Signal input is too weak.
“Miswiring DC Offset Error”/“Warning DC Offset
Error”:
• A speaker cord has shorted or it has come into
contact with the car chassis. Wire or insulate the
speaker cord as appropriate, then reset the unit.
(Pages 3 and 55 )
“Parking off”:
• No playback picture is shown when the parking
brake is not engaged.
“Authorization Error”:
• Check whether the connected iPod/iPhone is
compatible with this unit. (Page 62)
“USB Device Error”:
• The USB power voltage is abnormal.
• Turn off and turn on the unit.
• Connect another USB device.
“Panel Mecha Error”:
• The panel does not work properly. Reset the unit.
“No Navigation”:
• No navigation unit is connected.
“Connection Er ror”:
• The device is registered but the connection has
failed. Connect the registered device. (Page 32)
“Please Wait...”:
• The unit is preparing to use the Bluetooth
function. If the message does not disappear, turn
off and turn on the unit, then connect the device
again (or reset the unit).
“No Voice Device”:
• The connected mobile phone does not have a
voice recognition system.
“No Data”:
• No phone book data is contained in the connected
Bluetooth phone.
“Initialize Error”:
• The unit has failed to initialize the Bluetooth
module. Try the operation again.
“Dial Error”:
• Dialing has failed. Try the operation again.
“Hung Up Error”:
• The call has not ended yet. Park your car, and use
the connected mobile phone to end the call.
“Pick Up Error”:
• The unit has failed to receive a call.
REFERENCES
DDX_Mid_E.indb 63 2014/01/23 19:50