Kenwood KDC-BT60U - Manual (Page 63)

P.CONT
ANT.CONT
MUTE
REMOTE CONT
STEERING WHEEL
REMOTE INPUT
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
L R
L R
Battery wire (Yellow)
Ignition wire (Red)
FM/AM antenna input (JASO)
Antenna Cord
Wiring harness
(Accessory 1)
If no connections are made, do not
let the wire come out from the tab.
Power control/Motor antenna
control wire (Blue/White)
Mute control wire (Brown)
Connect either to the power control terminal when
using the optional power amplifier, or to the antenna
control terminal in the vehicle.
A–7 Pin (Red)
A–4 Pin (Yellow)
Connector A
Connector B
⁄ See next page
To Kenwood disc changer/External optional accessory
⁄ To connect these leads, refer to the relevant instruction
manuals.
Fuse (10A)
Front output
Rear output
Sub Woofer output
Connect to the terminal that is grounded when
either the telephone rings or during conversation.
(KDC-6047U only)
⁄ To connect the Kenwood navigation system,
consult your navigation manual.
Steering remote control wire
(Light Blue/Yellow)
USB connector (1m)
To USB device
⁄ Do not remove the
cap when you do not
use the USB cable. The
connector will cause
the unit to malfunction
if it gets in touch with
any metallic part of the
vehicle.
Microphone
(Accessory 3)
Microphone input
(KDC-BT60U only)
AUX input (Stereo)
Use the mini-plug which is stereo type
and does not have any resistance.
To use the steering wheel remote control feature, you
need to an exclusive remote adapter (not supplied)
matches your car is required.
English |
63
Connecting Wires to Terminals