Kenwood TK-2185E - Manual (Page 36)

26
S
cAnning
Press the Scan key (default: S key) to begin scanning.
• While scanning, the icon and “SCAN” appear on the display.
• When a call is received, scanning stops and the channel number (or
channel name if a name has been set up) appears. Press the PTT
switch and speak into the microphone to respond to the call. The
transceiver will continue scanning after an adjustable time delay if
the PTT switch is released and no further signal is received.
To stop scanning, press the Scan key again.
■
Add to Scan/ Delete from Scan
Press the Scan Delete/Add key (default: A key) to add or
remove each channel to or from the scan sequence.
• The channel add indicator ( ) will appear on
the display when the selected channel is added to the scan
sequence.
■
Scan Revert
During scan, when pressing the PTT switch, you can
transmit on the revert channel. Four types of Scan Reverts
which can be programmed by your dealer are available.
• Last Called: The last channel on which you received a call.
• Last Used: The last channel to which you responded.
• Selected: The channel you selected prior to activating Scan.
• Selected + Talkback: The channel you selected prior to
activating Scan is the revert channel. However, you can
respond (talkback) to a call if you are currently receiving on a
different channel.
e
mergency
(t
runking
)
The Emergency (Trunking) function will place an Emergency
Call (page 20) when entering Trunking mode.
• This function can be configured only when Trunking Search Delay
Time is not set to "Off" and Automatic Mode Change is set to "Alert".
• Emergency (Trunking) cannot be used if the Trunking Search has
not found a Control Channel.