Kenwood TK-2185E - Manual (Page 44)

4
■
Auto Reply Message (Trunking Mode Only)
You can set the transceiver to automatically respond to
Individual Calls:
1 Press the key programmed as Auto Reply Message to
enter Auto Reply Message mode.
• The Auto Reply Message indicator ( )
appears on the display.
2 When you receive an Individual Call, Auto Reply will
begin after waiting for  seconds, the transceiver
will send an automatic response to the caller, and
“GREETING” appears on the display.
• If you are available to receive the call, press any key to
disable the auto response.
• If memory is available on your transceiver for recording,
“I am not available. Leave your Message.” will be sent to
the caller. The caller can then leave a recorded message
on your transceiver which you can later recall and listen
to. When a message is stored on your transceiver, “MSG
RCVD” appears on the display.
• If no memory is available on your transceiver for recording,
“I am not available.” will be sent to the caller and “MEMORY
FULL” appears on the display.