Teledex E Series - Manual (Page 21)

E SERIES VoIP USER GUIDE www.teledex.com 21
IMPORTANT: Voice/Data VLAN differentiated IS
ALWAYS SET TO “Undifferentiated” in the drop down
menu.
DiffServ Value: The value range: 0x28,0x30,
0x38,0x48,0x50,0x58,0x68,0x70,0x78,0x88,0x90,0x
98,0xb8. (Default is 0xb8.) 0xb8 stands for best
fast transmission. 28–38 is for the transmission
priority of the first rank. 48–58 is for the
transmission priority of the second rank. 68–78
is for the transmission priority of the third rank.
88–98 is for the transmission priority of the fourth
rank.
Data 802.1P Priority: QoS (Quality of Service is
a 3-bit field called the Priority Code Point (PCP)
within an Ethernet frame header when using
VLAN tagged frames, as defined by IEEE 802.1Q.
It specifies a priority value of between 0 and 7
inclusive that can be used by QoS disciplines to
differentiate traffic. (0 is lowest priority traffic
and 7 is highest priority traffic.)
Data VLAN ID: Is used for establishing a secure
separate Virtual LAN for Guest Data traffic to the
Internet. The value ranges are 0–4095. Default
Value is 254.
3.5.7 DIGITAL MAP CONFIGURATION
The digital map is a set of rules to determine
when the user has finished dialing.
E Series phones support the following digital
map:
A digital map is based on rules judging when the
user stops dialing and when to send the string of
numbers to the server. E Series phones support
the following digital map:
– End With “#”: Use # as the end of dialing.
– Fixed Length: When the length of the dialing
matches, the call will be sent.
– Timeout: Specify the timeout of the last digit
dialed. The call will be sent after the timeout.
[ ] represents the range of digits used. It can be
a range such as [1–4] or it can use commas such
as [1,3,5] or it can use a list such as [234].
x represents any one digit between 0–9.
Tn represents the last digit for a timeout. It is
necessary for n to represent the time from 0–9
seconds. Tn must be the last alpha and digit in
the entry. If Tn is not included in the entry, we use
T0 as default: which means the system will send
the number immediately if the number matches
the entry.
EXAMPLES:
8[2-8]xxxxx All numbers from 8200000 to
8899999 will be sent immediately.
955xx5 Six–digit numbers that begin with 9 will
be sent immediately.
10060 The number 10060 will be sent immediately.
22xxxxx T1 Seven-digit numbers that begin with
22 will be sent after one second.
39[3,9]xxxx Seven-digit numbers beginning with
393 or 399 will be sent immediately.
BEST PRACTICES: DIAL PLAN PATTERNS
Below are some examples of best practices.
These examples will help those in a hospitality
environment to set up a useable dial plan.
The Dial Plan (Digital Map) is a set of patterns.
As the user dials, as soon as the digits entered
match one of the patterns, dialing is considered
complete and the call is initiated.