Teledex E Series - Manual (Page 30)

30 www.teledex.com E SERIES VoIP USER GUIDE
Reference—SIP Quick
Start to Register a
Single Phone
The Cetis, Inc., SIP phones are SIP-only endpoints
powered only by POE/802.3af and will acquire an
IP address when connected to a DHCP server.
Begin by plugging your POE Ethernet cable into
the WAN port. To retrieve an IP address, press
* * 4 7 # (* * I P #). The phone’s IP address will
be displayed on the LCD or spoken by audio
through the speaker. Point your Web browser to
that IP address. You will be presented with a login
screen.
Login = admin
Password = admin
This is the Default Current Status Page
The scope of this document is to provide the basic
screenshots necessary to quickly configure the
guest phone for basic registration and show the
user where to program the voice mail retrieval
keys and the speed dials. In our example, the SIP
phone is programmed as extension 1001. The
firmware version of the phone is circled in red.
Program Your Connection Under the VoIP -> SIP
Configuration
Screen
The Server Address of the IP/PBX, Extension
Number/Account Name, Phone Number, Display
Name, Enable Register, and Enable Message
Waiting indicators are all programmed here.
Speed Dial and OneTouch Message Keys Are
Programmed Under Advance -> Memory Key
MWI Number is the field for programming the red
Message Waiting Indicator OneTouch.
In this example, it is programmed to dial number
7001 on the IP/PBX for retrieving voice mail
messages.
Reset to Factory Default
To reset the phone to the factory default settings,
press “#” during the startup procedure. (At power
up you can see a black progress bar.) The phone
will enter into “post” mode, then input * # 1 6 8.
Then you will see “clearing conf” on the screen,
next you see “conf reset”. Now you have a reset to
the default settings. Lastly, cycle power (remove
and replace WAN power cable) to restart the
phone with factory default settings.