Teledex E Series - Manual (Page 22)

22 www.teledex.com E SERIES VoIP USER GUIDE
ELEMENTS IN A DIAL PLAN PATTERN:
X Matches any dialed digit, #, or *
0–9, *, # Matches the digit
[<digits>] Matches any one of the digits
between brackets
, Play a secondary dial tone if the
patter up to this point has been
matched, e.g. “9,1xxxxxxxxx”
means play a dial tone after a 9 is
entered.
Tn Additional digits may be dialed, but
the pattern will be matched when
n seconds elapse with no further
dialing
IN THE U.S., A RECOMMENDED MINIMUM DIAL
PLAN INCLUDES:
Item1 Rule :0
Item2 Rule :911
#Emergency
Number
Item3 Rule :9911 #Emergency
Number
Item4 Rule :[2–7]xxx #as needed to cover
internal numbers
Item5 Rule :91xxxxxxxxxx #as needed to cover
external numbers
3.5.8 CALL SERVICE
The user can also configure Call Service options
such as a hotline, call forward, call transfer, call
waiting, 3-way conference call, auto-answer, etc.,
on this page.
Hot Line: Configures the hotline number. If this
option is set, E Series immediately dials this
number when the handset is picked up, or the
speaker key is pressed, taking the phone off-
hook.
No Answer Time: The no answer/call forward
time setting. Default is 20 seconds before a call
forward.
P2P IP Prefix (Peer-to-Peer IP Prefix): Not
applicable for Hospitality environments. Sets the
Prefix for Peer-to-Peer IP calls. For example, if
you want to dial the number 192.168.1.119, you
define the P2P IP Prefix as “192.168.1.”. So you
dial only 119 to reach the number 192.168.1.119.
Default is “.”. If there is no “.” set, the result
disables the dialing IP.
Auto Answer: Enable/disable the auto-answer
function.
Do Not Disturb: DND (Do Not Disturb) enables
this option to refuse all calls.
Ban Outgoing: Enabling this bans outgoing calls.
Enable Call Transfer: This is used in business
sets to FWD (Forward) or transfer a call. It is not
enabled in hospitality sets.
Enable Call Waiting: Enable/disable the call
waiting option. (It is also necessary to disable Call
Waiting when enabling Call Forwarding under
VOIP -> SIP Configuration -> Advanced Set.)
Enable Three Way Call: Default is enabled,
allowing for conference calling.
Accept Any Call: Default is enabled. If this option
is disabled, the E Series phone refuses the
incoming call when the called number is different
from E Series phone number.
Black List: Any incoming call from these phone
numbers will be refused.
Limit List: Any outgoing calls using these phone
numbers will be refused.