U.S. Products CMX-20 ROTARY EXTRACTOR - Manual (Page 18)

Operating Instructions: 4-2
CMX-20
Electrical Cord Connection
The 50 ft electrical cord on your CMX-20 (120 V/60 Hz configuration) is a permanently
attached, three-prong grounded line requiring a three-prong, 15 Amp receptacle.
A three-prong to two-prong adapter may be used if its ground wire is properly attached
to a grounded terminal.
do not, under any circumstances, remove the ground prong from your CMX-20
power cord. Serious injury or death may result.
for best results, vacuum the carpet thoroughly prior to using the carpet cleaning
system.
OPERATION
Control functions
Control triggers are located on each side of the handle under the rubber hand grips (see
figure 4-2).
To operate the CMX-20, squeeze the 1. motor trigger on your right-hand side to
control the electric motor which drives the cleaning heads (see figure 4-2).
figure 4-2. Location of Control Triggers and Momentary Switch as Viewed from
front of Machine (Opposite of Operator’s Position)
Motor Trigger on OPERATOR’s
Right-Hand Side
Solution Trigger on OPERATOR’S
Left-Hand Side
Momentary Switch