Videotec NXW - Manual (Page 6)

EN - English - I
nstruc
tions manual
4
5 Preparing the
product for use
h Any change that is not expressly
approved by the manufacturer
will invalidate the guarantee.
5.1 Contents and unpacking
When the product is delivered, make sure that
the package is intact and that there are no
signs that it has been dropped or scratched.
If there are obvious signs of damage,
contact the supplier immediately.
Keep the packaging in case you need
to send the product for repairs.
Check the contents to make sure they correspond
with the list of materials as below:
• NXW housing
• Housing equipment:
• Allen wrench
• Spacers
• Screws and washers
• Screws for camera
• Instructions manual
5.2 Safely disposing of
packaging material
The packaging material can all be recycled.
The installer technician will be responsible for
separating the material for disposal, and in
any case for compliance with the legislation
in force where the device is to be used.
Bear in mind that if the material has to be returned
due to a fault, using the original packaging
for its transport is strongly recommended.
4 Identification
4.1 Product description
and type designation
The solid construction of this housing makes
it suitable for heavy duty applications, such
as the surveillance of ovens, foundries and
other high temperature environments.
The NXW housing is entirely constructed from
electropolished stainless steel and consists of a body
with a double chamber for the circulation of a cooling
liquid or air. The NXW is enclosed by two thick flanges
at either end and allows cables to pass through by
means of two PG13.5 cable glands on the back flange.
The front flange can be equipped with tempered
glass, IR glass or Vicor glass for higher temperature.
A special version is available with IR-proof glass.
Two 1/2” GAS connectors allow for the
cooling liquid inflow/outflow.
The NXW is equipped with a flange designed to
create an air barrier in front of the glass. This prevents
the formation of dust deposits and attenuates
the heat of the glass itself. With the supplied air
barrier, the NXFIGRU filter group is recommended,
which purifies the air drawn from a compressor.
4.2 Product markings
See the label attached to the outside of the package.