AMICA EKS 16161 DE - Manual (Page 49)

49
REVERSING THE DOOR OPENING DIRECTION
1. Before reversing the door opening direc-
tion, unplug the appliance and remove all
food.
2. Using a flat screwdriver pry and remove
hinge caps.
3. Using a Phillips screwdriver remove the
door upper hinge while holding the door (Fig.
2).
4. Using a Phillips screwdriver remove the
middle hinge while holding the upper door*
5. Set the door aside in a safe place.
6. Tilt the appliance (up to 40 degrees) so as
to have sufficient access to the lower hinge
(Fig. 3).
7. Using a Phillips screwdriver remove lower
door hinge
8. Attach the lower hinge on the other side
(Fig. 4).
9. Position the door assembly in such a
way so that pin of the lower hinge is aligned
with the appropriate hole of the lower door
bracket.
10. Attach the middle hinge on the other side
of the appliance so that the lower pin of the
middle hinge is aligned with the appropriate
hole of the upper door bracket. Position the
second door assembly so that the upper pin
of the middle hinge is aligned with the appro-
priate hole of the lower door bracket.*
11. Attach the upper hinge so that the hinge
pin is aligned with the appropriate hole of the
upper door bracket.* (Fig. 5).
12. Check that doors are properly aligned
with the appliance body.
13. Replace the hinge caps.
14. Switch on the appliance as described in
the relevant section of its operating instruc-
tions.
* This action applies to appliances with both
refrigeration and freezer chambers.
2
3
4
5