MagTek USB MagnePrint Swipe Reader with Encryption - Manual (Page 16)

USB MagnePrint Swipe Reader with Encryption
8
WINDOWS PLUG AND PLAY SETUP
On hosts with the Windows operating system, the first time the device is plugged into a specific USB
port, Windows will pop up a dialog box, which will guide you through the process of installing a device
driver for the device. After this process is completed once, Windows will no longer request this process
as long as the device is plugged into the same USB port. The device driver that Windows will install for
this device is the driver used for HID devices and it is part of the Windows operating system. When the
dialog box pops up, follow the instructions given in the dialog box. Sometimes Windows will find all the
files it needs on its own without giving any prompts. Other times Windows will need to know the
location of the files it needs. If Windows prompts for the file locations, insert the CD that was used to
install Windows on your PC and point Windows to the root directory of the CD. Windows should find
all the files it needs there.
MOUNTING
The Reader may be mounted with screws or fastening tape as described below.
1.
The Reader can be mounted on a surface in various ways:
•
By two screws through the surface attached to the bottom of the unit and running the cable on
the top of the surface
•
By two screws through the surface attached to the bottom of the unit and by drilling a hole in
the surface for the cable and running the cable through the hole
•
By attaching the unit to the surface with fastening tape and running the cable on the top of the
surface
Note
The two mounting inserts are 3mm diameter, 0.5mm pitch, 6.4mm deep.
The length of the screws used depends on the mounting surface thickness
and the thickness of washers (if used).
The mounting dimensions are shown in Figure 2-2. Determine the method of mounting required.