MagTek IntelliStripe65 99875141 - Manual (Page 15)

7
SECTION 2. INSTALLATION
The Installation of the IntelliStripe 65 Insertion Reader includes mechanical and electrical
connections.
BEZELS
There are three types of Bezels for this product: the North American Plastic Bezel, the
International Plastic Bezel, and the International Metal Bezel. The type of bezel used is relevant
to the mounting options described below. Appendix B contains illustrations and engineering
drawings describing the three bezels.
International Plastic Bezel
The International Plastic Bezel is larger than the other two bezels and requires a larger panel
opening. This bezel uses and is attached by metric screws. International Bezels are mounted to
the Reader Chassis by the Front Flange only. The dimensions of the recommended panel
opening for mounting are shown in Appendix B.
International Metal Bezel
The International Metal Bezel is slightly smaller than the International Plastic bezel but requires
the same size panel opening as the International Plastic Bezel. This bezel uses and is attached by
metric screws. International Bezels are mounted to the Reader Chassis by the Front Flange only.
The dimensions of the recommended panel opening for mounting are shown in Appendix B.
North American Plastic Bezel
The North American Bezel is smaller than both International Bezels and requires a smaller panel
cutout. This bezel follows the industry-standard footprint of MagTek the MT215 Insertion
Reader. This bezel uses and is attached by imperial screws. North American Bezels are
mounted to the Reader Chassis by the Side Mounting Studs only. The dimensions of the
recommended panel opening for mounting are shown in Appendix B.
MECHANICAL MOUNTING AND BEZELS
Mounting options for the Reader are as follows:
Front Flanges only (for International Bezels)
Side Mounting Studs only (for North American Bezels)
Side Mounting Holes only
Front Flanges and Side Mounting Studs together
Chassis mounting features are shown in Figure 2-1. Mounting dimensions are shown in Figure 2-2.
Descriptions of the mounting options are as follows: