MagTek IntelliStripe65 99875141 - Manual (Page 31)

Appendix B. Bezel Configuration and Mounting
23
NORTH AMERICAN PLASTIC BEZEL MOUNTING
The North American Plastic Bezel, P/N 21161206, is shown and described on Figures B-4, B-5,
B-6 and B7. The Bezel with the optional cutout for the LED, P/N 21161207, is shown and
described on Figures B-4, B-9, and B-10. The North American Bezel is smaller than the
International Bezels and requires a smaller panel opening for installation. The North American
Bezel is suited to applications requiring imperial screws. From the drawings in this section, the
user may design a bezel for different requirements.
Figure B-3 shows the orientation and dimensions of the bezel and recommended dimensions for
the panel opening. Four screws that mount the Bezel to the panel are size 6-32. The length of
the screws depends on the panel thickness, washers, and spacers used in mounting the panel.
Figures B-4 and B-5 show the dimensions of the bezel in case a different bezel is required.
Figures B-6 and B-7 show the brackets that are mounted on the side of the unit.