MagTek MT-215 TTL SINGLE HEAD, 3-TRACK - Manual (Page 8)

MT-215 TTL Single Head, 3-Track, Insertion Reader
2
SPECIFICATIONS
The specifications for the Reader are listed in Table 1-2.
Table 1-2. Specifications
OPERATING
Read-data Format
Specifications Supported ANSI/ISO/AAMVA/CDL/ 75 or 210 BPI on Track 1 (normally 210 BPI)
ANSI/ISO/AAMVA/CDL/ 75 or 210 BPI on Track 2 (normally 75 BPI)
ANSI/ISO/AAMVA/CDL/ 75 or 210 BPI on Track 3 (normally 210 BPI)
Power
Requirements Two Tracks: +5 VDC
±5% at 15mA
Three Tracks: +5VDC ±5% at 20mA
Power Consumption 0.095 to 0.105 WATTS
Output Signal Levels
V ol = 0.4 V @ 2.0 mA
V oh = Vcc -0.5 V @ 2.0 mA
Recording Method Two-frequency coherent phase (F2F)
Speed Card Speed: 3 to 50 IPS @ 75 or 210 BPI (7.6 to 127 cmps)
TRK 1 or 3: 75 or 210 BPI (MagTek decode ASIC is density
independent).
TRK 2: 75 or 210 (MagTek decode ASIC is density independent).
MTBF Electronics: 125,000 hours
Head: 1,000,000 passes (500,000 Insertion Cycles)
I/O Connector 11-pin Header, 0.100" centers, single in line.
MECHANICAL
Dimensions (with Bezel)
Length
Width
Height
Without bezel With Flat-faced Bezel With Extended Bezel
4.40" (11.2cm)
4.58“ (11.63cm) 5.09" (12.93cm)
3.51" (8.92cm) 4.00" (10.16cm) 4.00" (10.16cm)
1.24" (3.15cm) 3.00” (7.62cm) 3.00” (7.62cm)
Bezel Thickness Flat Faced: 0.31” (0.79cm); Extended: 0.82" (2.08cm)
Weight Without bezel With Flat-faced Bezel With Extended Bezel
2.25 oz. (65 gr.) 3.85 oz. (109 gr.) 4.02 oz.. (114 gr.)
ENVIRONMENTAL
Temperature
Operating
Storage
-30
o
C to 70
o
C (-26
o
F to 158
o
F)
-40
o
C to 80
o
C (-40
o
F to 176
o
F)
Humidity
Operating
Storage
10% to 90% noncondensing
Up to 100% noncondensing
Altitude
Operating
Storage
0-10,000 ft. (0-3,048 m.)
0-50,000 ft. (0-15,240 m.)