Packaging, wiring, and mounting, Packaging and pin assignments, Wiring – MagTek 3V & 5V User Manual
Page 9: Mounting, Table 1. signal and pin assignments, Intellihead, Figure 2. intellihead wiring
Shift-Out IntelliHead
5
PACKAGING, WIRING, AND MOUNTING
Packaging and Pin Assignments
Signal and pin assignments for the Shift-Out IntelliHead are shown in Table 1.
Table 1. Signal and Pin Assignments – IntelliHead
Pin Number
Description
1
STROBE
2
DATA
3
VDD
4
GND
5
CASE
Wiring
The Shift-Out IntelliHead Wiring Diagram is shown in Figure 2. The recommended mating connector
is Molex 53048-0510.
Figure 2. IntelliHead Wiring
Mounting
The Two-track Shift-Out IntelliHead drawing is shown in Figure 4. The Three-track Shift-Out
IntelliHead (Butterfly Spring) drawing is shown in Figure 3. The Three-track Shift-Out IntelliHead
(43mm Spring) drawing is shown in Figure 5. The Three-track Shift-Out IntelliHead (Accordion
Spring) drawing is shown in Figure 6.
Refer to the Reader Design Kit Specification, P/N 99821002, for complete mechanical mounting
information.