Waterloo F1521A1-3 - Manual (Page 7)

7
• Turn J over. (Use packaging material to avoid scratching.)
• Drill (6) 1/8" pilot holes 1/2" deep.
J
DD(6)
J
• Reposition J on unit.
• Attach with (6) DD.
• Reinstall drawers. (See drawer installation instructions.)
DD(6)
STEP 6 - Continued:
C Lubricate the slides with grease or equivalent, (twice yearly.)
C Periodically the drawer fronts, drawer trim and other surfaces
should be cleaned with a mild detergent and water.
C Auto wax will preserve the unit's luster finish. Apply the wax as
to a car. The wax will also help protect the unit against
scratches.
C Grease and oil can be removed with most standard cleaning
fluids. For safety, use a nonflammable cleaning fluid.
• Empty the drawer.
• Fully extend the drawer.
Release
• To reinstall, carefully align
the slides and slowly push
the drawer into the unit until
the drawer stops.
Lever Style - Lift or lower (depending on the
slide) the release lever on both sides, (this
allows the slides to ride over the stops.) Pull
out to remove.
Tab Style - Depress the release tabs on
both sides, (this allows the slides to ride over
the stops.) Pull out to remove.
REMOVING AND INSTALLING DRAWERS:
OPERATION
MAINTENANCE