Wagner Flexio 690 Sprayer - Manual (Page 6)

English
6 © Wagner Spray Tech. - All Rights Reserved
Assembly
Before you begin:
nEVER point the spray gun at
any part of the body.
note: Your unit includes two nozzle assemblies. See below
to determine the correct nozzle for your spraying project.
• Detail Finish Nozzle - used for
small projects and fine finishing.
Designed for spraying thinner
materials, such as water- and oil-
based stains and thinned paints.
The Detail Finish Nozzle leaves a
smooth finish.
• iSpray Nozzle - used for broad
surface coating. Designed for
spraying thicker materials, such as
latex paints and stains. Spraying
with this nozzle will leave a slightly
coarser finish that is between a
roller and fine-finish sprayer.
note: These two spray nozzles have different spray pattern
/ width controls. Make sure to familiarize yourself with the
controls on each spray nozzle. See the “Controls” section,
page 8-9.
To Assemble:
IMPORTanT: Make sure the power cord is unplugged.
1. Insert the suction tube into the intake opening.
2. align the suction tube -
a. If you are going to be spraying in a downward
direction, the angled end of the suction tube should
be pointing toward the front of the gun.
b. If you are going to be spraying in an upward direction,
the angled end of the suction tube should be pointing
toward the rear of the gun.
note: Make sure the suction tube is inserted as far as it will
go to ensure a tight fit.
3. Carefully screw the cup back onto the spray gun
assembly. Tighten firmly.
1
2a
2b
3