Wagner ProCoat Max - Manual (Page 13)

English 13
Spraying
Troubleshooting -
Clean the Spray
Gun Filter
Start You will need:
• Wrench
• Warm, soapy water for latex material
• Mineral spirits for oil based materials
• Replacement spray gun filter (if necessary)
ImPORTanT: never clean the filter by
poking it with a sharp object.
1. Peform the Pressure
Relief Procedure, page 7.
5. Inspect the filter for
damage. Replace if any
holes or tears are found.
4. Remove the filter from the
housing. Clean with appropriate
cleaning solution (warm, soapy
water for latex materials; mineral
spirits for oil-based materials).
2. Pull trigger guard
from filter housing.
6. Replace cleaned filter, tapered
end first, into the gun housing.
note: It is important to place tapered
end first to ensure proper sprayer
operation.
3. Tighten the wrench over the
wrench flats (a). Unscrew the
filter housing using a wrench.
note: You DO NOT need to
remove the spray hose from the gun
to clean the filter.
7. Reassemble the spray gun.
PRIME
1
5 4
2
6
(a)
3
7