Cleanup - oil-based materials, 18 cleanup - oil-based materials, Start you will need – Wagner ProCoat Max User Manual
Page 18
English
18
Cleanup -
Oil-Based
Materials
Start
You will need:
• Mineral spirits if using oil-based material
• Warm, soapy water if using latex material
• Waste container
Follow these steps if you sprayed oil-based
materials, or if you sprayed latex materials
and do not have a garden hose available.
Be sure to use the appropriate cleaning
solution for the type of material sprayed.
1. Perform Pressure Relief
5. While squeezing the
trigger, turn the power
ON, and turn the PRIME/
SPRAY knob to SPRAY -
MINIMUM PRESSURE.
4. Point the spray gun at the side of
a waste container. ground the
gun against the side of a metal
waste container if flushing
with mineral spirits.
2. Remove the spray tip
and place into an empty
waste container.
6. Continue squeezing the trigger
until fluid is coming out clear.
You may need to get new
cleaning solution.
3. Submerge suction set into a
bucket with the appropriate
cleaning solution.
If you flushed the sprayer with mineral
spirits repeat the steps on this page
using warm, soapy water.
PRIME
l
O
1
5
4
2
6
PRIME
3
7
ON