Horner APG QX651 OCS - Manual (Page 2)

MAN0797-03-EN Specifications / Installation
__________________________________________________________________________________________________________________________________________________
9/16/2009 Page 2 of 7 ECN # 968
3 INSTALLATION
3.2 Panel Cut-Out and Dimensions
3.2.1
QX451 (8-inch)
Note: Prior to mounting, observe requirements for the panel layout design and adequate clearances in the QX Hardware Manual (MAN0798). A handy checklist is provided in the
Installation chapter.
3.1
Installation Procedures
a.
QX Base Installation
1. Per specifications of the QX model you are using, carefully prepare the panel cutout. Make sure the corners of the cutout are square and free from burrs. (Locate the panel
cut-outs and dimensions that pertain to your QX model as shown in this document.)
2. Cut the host panel
3. Insert the QX (base unit only) through the panel cutout from the front. The gasket material needs to lie between the host panel and the QX.
4. Install and tighten the mounting clips (provided with the QX) until the gasket material forms a tight seal.
5. If used, install the Back Pack (BP) option. (Refer to Item b in this section for details.)
Note (Backpack sold separately in North America Only): QX units are shipped with firmware that requires a Backpack for proper boot up to complete. If a Backpack is
not to be used, a QX firmware update from Cscape must be performed for proper operation.
6. Connect cables as needed such as communications, programming, power and fiber optic cables to the QX ports using the provided connectors.
7. As a final step before using, carefully remove the protective, plastic sheet from the front of the unit. The protective, transparent sheet is used to protect the display window.
8. Begin configuration procedures for the QX.
b.
Back Pack (BP) Installation (Backpack sold separately in North America Only)
Note: QX Bases are not shipped with firmware that is compatible with the Back Pack option.
A firmware update is performed as part of the BP installation procedure in this section.
1. Remove the clear plastic label on the unit.
2. Push the BP into place on the QX Base.
3. Insert and tighten the 3 screws.
4. If installing BP Rev G and beyond use spacer CAB000023 as shown in the Figure 1
for the screw closest to the BP connector
Caution: Do not force the QX into the panel cutout. An incorrectly sized panel cutout damages the QX screen.
Caution: Do not over-tighten. Over-tightening damages the case.
Spacer
Horner Part No: CAB00023
Caution: Do not over-tighten. Over-tightening damages the case.
Figure 1 – BP Rev G Spacer Installation
Figure 2 – Panel Cut-out and Dimensions 8-inch
3.37"
(85.6 mm)
0.83"
(21.1 mm)
9.17"
(233.0 mm)
7
.0
"
(1
7
8
.0
m
m
)
001QX001-R1
2.35"
(59.70 mm)
Back Pack
SmartStack
I/O Back Pack
QX
QX Side View QX Rear View
001OCS017
8.69 [220.7mm]
6.53 [165.9mm]
QX Panel Cut-Out